How do i properly charge a car audio amp capacitor?? - car amp capacitor
I do not understand the method of resistance, or even how it will look like a cover of his age, MA Audio, you can only be bad?, A numerical display, and when I touch the battery cable that usually goes to " amplifiers for fast, that reading 5,6,7,8,9 backup. I do not know if it comes with a kind of tool shop or not, when I bought it. I was wondering if anyone one way to explain to me, has slowly, lol
Thanks
Tuesday, January 5, 2010
Car Amp Capacitor How Do I Properly Charge A Car Audio Amp Capacitor??
3 comments:
Out of nowhere ....
A limit should be loaded just before feeding them.
It is better to install as close to the amplifier. You may need the power and ground cable besides the same size it is now. Otherwise, cut the power wire on the ground and sufficient space for installation. The total length of ground wire as short as possible (18 "or less, if possible, not critical).
Remove the fuse from the battery. If you do not do this, you need one, which is the same as the total number of backups that are on the amplifier. Shall be no larger than 18 "battery pack.
Connect chassis ground of the CAP (-), then the amplifier (-).
Plug the power cord (fused battery) to (+), then the amplifier (+).
To load the CAP, will receive a 12V light bulb with a son. Temporarily connect the power cord from the battery on one side of the piston (s) on the fuse and connect the other side of the light bulb goes on over. The light bulb over a period of time (10-20 seconds) WilL getting dimmer. When the light goes out, takes care of the CAP. Basically you go to the backup center stood.
Now you can install the backup.
_________________
Well Specialteez,
The bulb and the circuit is completed, because it Ligths load. When the cap of the potential of food reached, the focus is stopped and more precarious. The cover will be charged.
Because the lid is finally, the battery is connected via the power cord, still has the power.
Out of nowhere ....
A limit should be loaded just before feeding them.
It is better to install as close to the amplifier. You may need the power and ground cable besides the same size it is now. Otherwise, cut the power wire on the ground and sufficient space for installation. The total length of ground wire as short as possible (18 "or less, if possible, not critical).
Remove the fuse from the battery. If you do not do this, you need one, which is the same as the total number of backups that are on the amplifier. Shall be no larger than 18 "battery pack.
Connect chassis ground of the CAP (-), then the amplifier (-).
Plug the power cord (fused battery) to (+), then the amplifier (+).
To load the CAP, will receive a 12V light bulb with a son. Temporarily connect the power cord from the battery on one side of the piston (s) on the fuse and connect the other side of the light bulb goes on over. The light bulb over a period of time (10-20 seconds) WilL getting dimmer. When the light goes out, takes care of the CAP. Basically you go to the backup center stood.
Now you can install the backup.
_________________
Well Specialteez,
The bulb and the circuit is completed, because it Ligths load. When the cap of the potential of food reached, the focus is stopped and more precarious. The cover will be charged.
Because the lid is finally, the battery is connected via the power cord, still has the power.
Hey Sparky, I have a simple question, what is a bulb in a ceiling? and it will always be charged or having to recharge once a month or somthing?
Post a Comment